Operation In The Recycler; Mode; Positioning The Seat; Adjusting The Motion Control - Toro 74432 Operator's Manual

Operation in the Recycler

Mode

Air is required to cut and recut grass clippings in
the mower housing, so do not set the height-of-cut
too low or completely surround the housing by
uncut grass. Always try to have one side of the
mower deck free from uncut grass; allowing air
to be drawn into the mower deck. When making
an initial cut through the center of an uncut area,
operate the machine slower and back up if the
mower starts to clog.
To ensure optimum performance, clean the
underside of the mower housing after each use.
If residue is allowed to build up in the mower
housing, cutting performance can decrease.
For the best performance of the Recycler
• Mow regularly.
• Keep air flow high by overlapping cutting paths
• Use an higher height of cut for taller grass.
• Use sharp blades.
• Travel at slower speeds when mowing taller
grass.

Positioning the Seat

The seat can move forward and backward.
Position the seat where you have the best control
of the machine and are most comfortable.
1. Raise the seat and loosen the adjustment knobs
enough to move the seat (Figure 20).
Important: Make sure that the spacers
stay in place when loosening the knobs
to move the seat. Loss of the spacers can
result in damage to the seat.
2. Move the seat to the desired position and
tighten the knobs.
®
1. Adjustment knobs
Adjusting the Motion
® mode:
Control Levers
The motion control levers can be adjusted higher
or lower for maximum operator comfort.
1. Remove the 2 bolts holding the control lever
to the control arm shaft (Figure 21).
2. Move the control lever to the next set of holes.
Secure the lever with the 2 bolts (Figure 21).
1. Control lever
2. Bolt
3. Repeat the adjustment for the opposite control
lever.
24
Figure 20
Figure 21
3. Control arm shaft