Toro Z597-D Z Master Setup Instructions page 3

Figure 4
4. Mount the wheels with the valve stem to the
outside and secure them with the wheel nuts
previously removed.
5. Torque the wheel nuts to 95 ft-lb (128 N·m).
6. Remove the jack-stands.
Figure 5
Step
4
Installing the Roll Over
Protection System
Parts needed for this step:
1 Roll bar, right section
1 Roll bar, left section
1 Roll bar, center section
8 Bolt (3/8 x 1 inch)
8 Curved washer
8 Flange nut (3/8 inch)
2 Bolt (1/2 x 3-1/4 inch)
2 Flange nut (1/2 inch)
Procedure
1. Loosely install the right and left roll bar section
to the frame, with 8 bolts (3/8 x 1 inch), 8
curved washers, and 8 flange nuts (3/8 inch).
Note: The curve washer cone must be
installed toward the bolt head.
Figure 6
2. Install the lanyard clips onto the long bolts
(1/2 x 3-1/4 inch).
Note: Make sure the bent tab points toward
the head of the bolt.
3