Table of Contents
Advertisement
11. Install the belt covers onto the cutting unit, then install
and tighten the knobs.
12. Install the carrier frame cover onto the cutting unit,
then install and tighten the hand knobs.
5
3
4
Figure 62
1. PTO engagement pulley
2. PTO drive belt idler
3. PTO drive Belt
Replacing the Castor Wheel
Fork Bushings
The castor wheel forks are mounted in bushings pressed
into the top and bottom of the carrier frame mounting
tubes. To check the bushings, move the castor forks back
and forth and side-to-side. If a castor fork is loose, the
bushings are worn and must be replaced.
1. Raise the cutting unit so the castor wheels are off the
floor, then block up the front of the mower with jack
stands.
2. Remove the locking pin and spacer(s) from the top of
the castor wheel fork (Fig. 63).
1
6
2
5
m–5194
4. Center Spindle Pulley
5. PTO Drive belt guide
6. Idler Spring
38
3. Pull the castor wheel fork out of the mounting tube,
leaving the spacer(s) on the bottom of the fork.
Remember the location of the spacers on each fork to
ensure correct installation, and to maintain a level
deck.
1
3
4
Figure 63
1. Locking Pin
2. spacers (locate as
required)
4. Insert a pin punch into the mounting tube and carefully
drive out the bushings (Fig. 64). Clean the inside of
the mounting tube.
5. Grease the inside and outside of the new bushings. Use
a hammer and flat plate to carefully drive the bushings
into the mounting tube.
6. Inspect the castor wheel fork for wear and replace if
necessary (Fig. 63).
7. Slide the castor wheel fork through the bushings in the
mounting tube. Replace the spacer(s) onto the fork and
secure with the retaining ring (Fig 63).
Important
The inside diameter of the bushings may
collapse slightly when installed. If the castor wheel fork
does not slide into the new bushings, ream both bushings
to an inside diameter of 1.126 in. (28.6mm).
2
2
3. Carrier Frame Mounting
Tube
4. Castor Wheel Fork
Advertisement
Table of Contents
