Greasing And Lubrication - Toro 30259 Operator's Manual

2
1
Figure 30
1. Center electrode insulator
2. Side electrode
Installing the Spark Plug
1. Install the spark plug(s). Make sure the air gap is set
correctly.
2. Tighten the spark plug(s) to 11 ft-lb (15 N m).
3. Push the wire(s) onto the spark plug(s) (Fig. 29).

Greasing and Lubrication

Service Interval/Specification
Refer to the CHECK SERVICE REFERENCE AID decal
for location and interval of greasing and lubrication
(Figure 31).
Grease with No. 2 general purpose lithium base or
molybdenum base grease.
How to Grease
1. Disengage the power take off (PTO), set the parking
brake, and turn the ignition key to off. Remove the
key.
2. Clean the grease fittings with a rag. Make sure to
scrape any paint off the front of the fitting(s).
3. Connect a grease gun to the fitting. Pump grease into
the fittings until grease begins to ooze out of the
bearings.
4. Wipe up any excess grease.
Where to Add Grease
Lubricate the grease fittings as shown on the CHECK
SERVICE REFERENCE AID decals (Fig. 31).
3
0.030 in.
(0.75 mm)
3. Air gap (not to scale)
(s)
27
Figure 31
Lubricate the castor and wheel bearings
1. Lubricate the front wheel bearings and front spindles
until grease begins to ooze out of the bearings
(Fig. 32).
2. Remove rear wheel grease cap. Lubricate the rear
wheel bearing (Fig. 32).
Note: Make sure the rear wheel grease caps are removed
before lubricating rear wheels.
Figure 32
Lubricate the transmission couplers
1. Lubricate the transmission couplers located in the back
of the machine (Fig. 32).
m–2147