Table of Contents
Advertisement
4.
When transaxle is cold add oil to "Full Cold"
line on reservoir (Fig. 34).
IMPORTANT: Do not fill above the full cold
line as fluid may overflow.
1
Figure 34
1. Fluid reservoir
Fuse
Service Interval/Specification
The electrical system is protected by fuses. It requires
no maintenance, however, if a fuse blows check
component/circuit for malfunction or short. To
replace fuses pull up on the fuse (Fig. 35) to remove
or replace it.
Fuse:
F1–30 amp, blade-type, Main/Starter
F2–25 amp, blade-type, Regulator
F3–10 amp, blade-type, Dash
F4–10 amp, blade-type, Headlights
F5–25 amp, blade-type, Lift
2
1243
2. Full cold level
Figure 35
1. Dash and Cruise control
-10 Amp
2. Head lights-10 amp
Headlights
Specification: Bulb # 1156 Automotive Type
Removing the Bulb
1.
Disengage the power take off (PTO), set the
parking brake, and turn the ignition key to
"OFF" to stop the engine. Remove the key.
2.
Open the hood. Pull wire connectors off both
bulb holder terminals.
3.
Rotate the bulb holder 1/4 turn counterclockwise
and remove it from the reflector (Fig. 36).
4.
Push and rotate the bulb counterclockwise until
it stops (approx. 1/4 turn) and remove bulb from
the bulb holder (Fig. 37).
Maintenance
4
3
2
2337
1
5
3. Regulator-25 amp
4. Main-30 amp
5. Lift 25 amp
33
Advertisement
Table of Contents
