Transaxle Fluid; Fuse; Headlights - Toro 72108 Operator's Manual

Transaxle Fluid

Service Interval/Specification
The transaxle is a sealed system and no checking or
changing of the fluid is required.
IMPORTANT: If any transaxle problems
arise, contact your local Authorized Service
Dealer for help and service.

Fuse

Service Interval/Specification
The electrical system is protected by fuses. It requires
no maintenance, however, if a fuse blows check
component/circuit for malfunction or short. To
replace fuses pull up on the fuse (Fig. 34) to remove
or replace it.
Fuse: Main/Starter F1–30 amp, blade-type
Alternator F2–25 amp, blade-type
Dash/Hour meter F3–10 amp, blade-type
Head lights F4–10 amp, blade-type
Figure 34
1. Main-30 amp
2. Alternator-25 amp
4
3
2
1
2344
3. Dash/Hour meter-10 Amp
4. Head lights-10 amp

Headlights

Specification: Bulb # 1156 Automotive Type
Removing the Bulb
1. Disengage the power take off (PTO), set the
parking brake, and turn the ignition key to
"OFF" to stop the engine. Remove the ignition
key.
2. Open the hood. Pull wire connectors off both
bulb holder terminals.
3. Rotate the bulb holder 1/4 turn counterclockwise
and remove it from the reflector (Fig. 35).
4. Push and rotate the bulb counterclockwise until
it stops (approx. 1/4 turn) and remove bulb from
the bulb holder (Fig. 36).
5
3
2
4
Figure 35
1. Bulb holder
2. Reflector
3. Tabs
Maintenance
5
1
4
4. Slots
5. Terminals
31