Stopping The Machine; Adjusting The Height Of Cut - Toro 78922 Operator's Manual

Stopping the Machine

To stop the machine, move the traction control levers
to neutral and move to locked position, disengage the
power take off (blade control switch (PTO), and turn
the ignition key to off.
Set the parking brake when you leave the machine; refer
to Setting the Parking Brake in Operation. Remember
to remove the key from the ignition switch.
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the tractor while it is
unattended.
Always remove the ignition key and set the parking
brake when leaving the machine unattended, even
if just for a few minutes.

Adjusting the Height of Cut

Using the Transport Lock
The transport lock has two positions and is used with
the deck lift pedal. There is a lock position and a unlock
position for the transport position. The transport lock
is used with the deck lift pedal. Refer to Figure 26
Transport Lock Positions
1. Transport lock
2. Lock position—mower
deck will lock into transport
position
22
Figure 26
3. Unlock position—does not
lock the mower deck into
transport position