Stopping The Machine; Adjusting The Height Of Cut; Positioning The Seat - Toro 74380 TimeCutter Z4200 Operator's Manual

To turn, release pressure on the motion control lever
toward the direction you want to turn (Figure 13).
The farther you move the motion control levers in
either direction, the faster the machine will move in
that direction.
To stop, pull the motion control levers to neutral.
Backward
1. Move the levers to the center, unlocked position.
2. To go backward, slowly pull the motion control
levers rearward (Figure 13).
To go straight, apply equal pressure to both motion
control levers (Figure 13).
To turn, release the pressure on the motion
control lever toward the direction you want to turn
(Figure 13).
To stop, push the motion control levers to neutral.

Stopping the Machine

To stop the machine, move the motion control levers to
neutral and outward to the park position, disengage the
blade control switch, ensure the throttle is in the fast
position, and turn the ignition key to off. Remember to
remove the key from the ignition switch.
Children or bystanders may be injured if they
move or attempt to operate the mower while it
is unattended.
Always remove the ignition key and move the
motion control levers outward to the park
position when leaving the machine unattended,
even if just for a few minutes.

Adjusting the Height of Cut

1. Raise the height-of-cut lever to the transport
position, cutting height position G (also the
4-1/2 inch [115 mm]) (Figure 14).
4-1/2 in (1 15 mm)
4-1/2 in (1 15 mm)
4 in. (102 mm)
4 in (102 mm)
3-1/2 in (89 mm) 3-1/2 in (89 mm)
3 in (76 mm)
3 in (76 mm)
2-1/2 in (64 mm)
2-1/2 in (64 mm)
2 in ( 51 mm)
2 in ( 51 mm)
1-1/2 in (38 mm)
1-1/2 in (38 mm)
1. Height-of-cut lever
2. To adjust the height of cut, pull inward and up on
the lever and move it to the desired position.

Positioning the Seat

The seat can move forward and backward. Position the
seat where you have the best control of the machine
and are most comfortable.
1. Raise the seat and loosen the adjustment knob just
enough that seat can move (Figure 15).
1
G005061
1. Adjustment knob
2. Move the seat to the desired position and tighten
the knob.
17
1
G
F
2
G006360
Figure 14
2. Height-of-cut positions
Figure 15