Toro 74246 Operator's Manual page 47

If one front chain is loose, raise (tighten) the front
support arm for that chain. Refer to Adjusting the
Front–to–Rear Mower Pitch on page 47.
Leveling the Mower Side–to–Side
1. Position the right blade front-to-rear (Fig. 66).
2. Measure the right blade at the B location (Fig. 66),
from a level surface to the cutting edge of the blade tip
(Fig. 67).
3. Record this measurement. This measurement needs to
be 3–1/8 to 3–1/4 inches.
4. Position the left blade front-to-rear (Fig. 66).
5. Measure the left blade at the C location (Fig. 66), from
a level surface to the cutting edge of the blade tip
(Fig. 67).
6. Record this measurement. This measurement needs to
be 3–1/8 to 3–1/4 inches.
Front
C
Figure 66
MEASURE FROM
CUTTING EDGE TO A
LEVEL SURFACE
Figure 67
7. If the measurements at positions B or C are not
correct, loosen the bolt attaching the rear chain to the
rear support arm (Fig. ).
8. Loosen the jam nut under the rear support arm and
adjust the adjustment bolt to get a measurement of
3–1/8 to 3–1/4 inches.
Note: It is recommended that both sides of the mower are
adjusted the same distance.
9. Tighten the jam nut under the rear support arm and
tighten the bolt securing the chain to the rear support
arm.
10. Adjust the opposite side if needed.
2
1
3
1
1. Rear chain
2. Rear support arm
3. Bolt
4. Jam Nut
Adjusting the Front–to–Rear Mower Pitch
1. Position the right blade front-to-rear (Fig. 69).
2. Measure the right blade at the A location (Fig. 69),
B from a level surface to the cutting edge of the blade tip
m–1078
(Fig. 70).
3. Record this measurement.
4. Measure the right blade at the B location (Fig. 69),
from a level surface to the cutting edge of the blade tip
(Fig. 70).
5. Record this measurement.
6. The mower blade should be a 1/4 to 3/8 inch
(6 to 10 mm) lower at position A than at position B
(Fig. 69). If it is not correct, proceed to the following
m–2539
steps.
47
Front
2
4
5
Figure 68
5. Adjustment bolt
6. Front swivel
7. Front support arm
Front
A
B
Figure 69
6
7
m–6830
m–1078