Using The Z Stand - Toro 74246 Operator's Manual

60 in turbo force side discharge mower
Table of Contents

Advertisement

Warning
Loading a unit onto a trailer or truck increases
the possibility of backward tip–over and could
cause serious injury or death.
Use extreme caution when operating a unit on a
ramp.
Use only a single, full width ramp; Do Not use
individual ramps for each side of the unit.
If individual ramps must be used, use enough
ramps to create an unbroken ramp surface
wider than the unit.
Do not exceed a 15 degree angle between ramp
and ground or between ramp and trailer or
truck.
Avoid sudden acceleration while driving unit up
a ramp to avoid tipping backward.
Avoid sudden deceleration while backing unit
down a ramp to avoid tipping backward.
1
1
m–6841
Figure 28
1. Trailer
2. Full width ramp
3. Not greater than
15 degrees

Using the Z Stand

The Z Stand is used for raising the front end of the
machine. This allows for cleaning of the mower and
removal of the blades.
4
2
3
4. Full width ramp—side
view
26
Warning
Unit could fall onto someone and cause serious
injury or death.
Use extreme caution when operating unit on
Z Stand.
Use only for cleaning mower and removing
blades.
Do not keep unit on Z Stand for extended
periods of time.
Always turn the engine off, set the parking
brake and remove the key before performing
any maintenance to mower.
Driving up onto the Z Stand
Important
Use the Z Stand on a level surface.
1. Raise the mower to the transport position.
2. Remove the bracket pin (Fig. 29).
2
5
1
3
Figure 29
1. Z Stand
2. Latch
3. Bracket
1
2
Figure 30
1. Z Stand (Positioned in
slot)
4
m–5599
4. Bracket Pin
5. Bottom of slot
3
m–5600
2. Crack in side walk or turf
3. Latch resting on pivot tab

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Z master z557Z557 z master

Table of Contents