Toro 70186 Operator's Manual page 18

6. Raise the grass collector and remove the hairpin,
2 washers, and clevis pin that secure the discharge tube
to the rear plate (Fig 13).
2
3
5
Figure 13
1. Rear plate
2. Discharge tube
3. Clevis pin
7. Remove the nut and outer washer that secure the
discharge chute to the discharge tube (Fig. 14).
1
Figure 14
1. Discharge tube
2. Nut and outer washer
8. Move the height-of-cut lever to the lowest position.
4
1
m-6339
4. Hair pin
5. Washers
3
m-6340a
2
3. Discharge chute
18
9. Remove the bolt, washer, and nut that secure the 2 strap
ends together (Fig. 15).
1
Figure 15
1. Straps
2. Nut
10. Move the straps away from the the discharge chute.
Note: Do not remove the straps from the mower
housing. If a strap comes off the housing, insert it as
shown in Figure 16.
1
Figure 16
1. Inserting the strap into the
slot
11. Remove the discharge chute from the mower housing.
Note: Attach the nut and outer washer that you
removed to the discharge chute to prevent losing them.
12. Install the Recycler cover onto the mower.
13. Join the 2 strap ends around the Recycler cover as
shown (Fig. 15).
14. Align the holes in the strap ends and fasten them
together snugly with the bolt, washer, and nut you
previously removed.
15. Raise the grass collector and install the clevis pin,
2 washers, and hairpin to secure the discharge tube to
the rear plate (Fig 13).
4
3
2
m-6338a
3. Bolt
2
m-6362/m-6363
2. The strap is inserted into
the slot