Table of Contents
Advertisement
4. Place the forks and counter balance on the rotisserie rod in the desired location.
5. Place the rotisserie rod into the motor. Align the rotisserie rod groove over the right inner hood wall and drop it
into the cut out provided on the inner hood. (Fig.5)
Figure 4
Installing in an outdoor cabinet:
A.
This grill must be safely and correctly installed as a built in, before being used. Please refer to the chart below, for
correct installation dimensions.
Framing must enclose the grill on the back and sides, but the bottom of the cut-out may be left open. The grill is
supported by the three flanges (left, right and rear), so no support underneath is required. NOTE: please ensure that
fuel line openings provide adequate space for the lines.
CABINET FRAMING DIMENSIONS:
*NOTE: Rear cabinet back splash (if applicable) must be non-combustible.
Q*
A
D
B
Cut Out (Framing) Dimensions:
E
C
Figure 5
Built In Grill Cutout Dimensions
Cabinets with Non-Combustible Materials
(Eg: metal studs, cement board, tiles, marble)
MODEL
Lux
JLS 550 Bi
*B
*C
*D
*E
*Q
8
Rotisserie Kit installed
A
B*
C*
Width
Depth
Height
24 ¾"
18 ¾"
10"
Depth is measured from the finished
face of the island/cabinet. Notching of
countertop front may be required.
Height is measured from the finished
countertop down.
Minimum distance to rear vertical wall;
required to fully open lid (from cutout).
Minimum distance to side or rear
adjacent vertical combustibles (counter
Top MUST be non-combustible).
Combustibles permitted over 5 feet
above grill.
D*
E*
5 ½"
36"
Advertisement
Table of Contents
