Table of Contents
Advertisement
Troubleshoot Your Network Using the Ping Utility
Most network devices and routers contain a ping utility that sends an echo request packet to the designated device.
The device then responds with an echo reply. You can easily troubleshoot a network using the ping utility in your
computer or workstation.
Test the LAN Path to Your Router
You can ping the router from your computer to verify that the LAN path to your router is set up correctly.
To ping the router from a Windows computer:
1.
From the Windows toolbar, click the Start button and select Run.
2.
In the field provided, type ping followed by the IP address of the router, as in this example:
ping www.routerlogin.net
3.
Click the OK button.
You see a message like this one:
Pinging <IP address > with 32 bytes of data
If the path is working, you see this message:
Reply from < IP address >: bytes=32 time=NN ms TTL=xxx
If the path is not working, you see this message:
Request timed out
If the path is not functioning correctly, one of the following problems might be occuring:
•
Wrong physical connections
For a wired connection, make sure that the numbered LAN port LED is lit for the port to which you are connected.
Check that the appropriate LEDs are on for your network devices. If your router and computer are connected
to a separate Ethernet switch, make sure that the link LEDs are lit for the switch ports that are connected to
your computer and router.
•
Wrong network configuration
Verify that the Ethernet card driver software and TCP/IP software are both installed and configured on your
computer.
Verify that the IP address for your router and your computer are correct and that the addresses are on the same
subnet.
Nighthawk X8 AC5000 Tri-Band WiFi Router
Troubleshooting
182
Advertisement
Table of Contents
