I/O Support Bracket - HP ZBook Studio G4 Maintenance And Service Manual

I/O support bracket

Description
I/O support bracket (included in Bracket Kit, spare part number 840966-001)
Before removing the I/O support bracket, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
6. Remove the thermal module (see
7. Remove the display cable (see
8. Remove the solid-state drive (see
9. Remove the WLAN module (see
10. Remove the system board (see
Remove the I/O support bracket:
▲ Lift the I/O support bracket straight up and off the system board.
Reverse this procedure to install the I/O support bracket.
Bottom cover on page
Battery on page 41).
Thermal module on page
Display cable on page
Solid-state drive (M.2) on page
WLAN module on page
System board on page
29).
38).
45).
31).
33).
46).
Component replacement procedures
Spare part number
840966-001 (Bracket Kit)
49