Led Board - HP ZBook Studio G4 Maintenance And Service Manual

LED board

Description
LED board
Before removing the LED board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
Remove the LED board:
1. Disconnect the cable from the system board (1).
2. Remove the two Phillips PM2.0×2.0 broadhead screws (2) that secure the LED board to the computer.
3. Remove the LED board (3).
Reverse this procedure to install the LED board.
Bottom cover on page
Battery on page 41).
29).
Component replacement procedures
Spare part number
922947-001
43