Stihl MS 201 C-M Instruction Manual page 21

Mounting the Guide Bar
1
2
Turn the screw (1)
N
counterclockwise until the tensioner
slide (2) butts against the left end of
the housing slot.
3
4
Fit the guide bar over the stud (3)
N
and engage the peg of the tensioner
slide in the hole (4).
Fitting the Chain
WARNING
Wear work gloves to protect your hands
from the sharp cutters.
MS 201 C-M
1
Fit chain around the sprocket (1)
N
and over the guide bar – the cutting
edges on top of the bar must point to
the bar nose.
2
Turn the screw (2) clockwise until
N
there is very little chain sag on the
underside of the bar – and the drive
link tangs are engaged in the bar
groove.
Refit the chain sprocket cover –
N
the pivot pin on the hand guard must
engage the sleeve – and then screw
the nut onto the stud finger-tight.
Go to chapter on "Tensioning the
N
Saw Chain"
English
19