Speakers
Description
Speaker Kit (includes left and right speakers, cables, and four rubber isolators)
Before removing the speakers, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the battery (see
a.
Bottom cover (see
b.
Hard drive (see
c.
WWAN module (see
d.
Keyboard/top cover (see
e.
System board (see
Remove the speakers:
1.
Release the speaker cable from the routing clip (1) built into the base enclosure.
2.
Remove the two Phillips PM2.0×5.5 shoulder screws (2) that secure the speakers to the base enclosure.
3.
Remove the speakers (3).
NOTE:
of or damage to these isolators can cause degradation to speaker performance.
Battery on page
Bottom cover on page
Hard drive on page
WWAN module on page
Keyboard/top cover on page
System board on page
When removing the speakers, make note of the location of the four rubber isolators. Removal
24), and then remove the following components:
26)
28)
33)
47)
55)
Spare part number
809870-001
Component replacement procedures
61