Counterweight - HP ProBook 11 G2 Education Edition Maintenance And Service Manual

1. Release the ZIF connector (1) to which the hard drive LED board cable is attached, and then disconnect
the hard drive LED board cable from the system board.
2. Remove the Phillips PM2.0×3.7 broad head screw (2) that secures the hard drive LED board to the
base enclosure.
3. Remove the hard drive LED board (3).
Reverse this procedure to install the hard drive LED board.

Counterweight

Description
Counterweight
Before removing the counterweight, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Bottom cover (see
b. Hard drive (see
c. Keyboard/top cover (see
Remove the counterweight:
1. Remove the two Phillips PM2.5×5.4 screws (1) that secure the counterweight to the base enclosure.
Battery on page 24), and then remove the following components:
Bottom cover on page
Hard drive on page 28)
Keyboard/top cover on page
26)
47)
Component replacement procedures
Spare part number
809860-001
53