Installation - Ericsson BML 161 51/022 Operator's Manual

1. STANDARD DESK CHARGER: Locate the Standard Desk Charger
on a desk or other flat surface near a 120/220Vac 50/60 Hz source.
Connect the plug end of the power cable into the power jack located
on the rear of the charger. Plug the "wall cube" power supply into the
outlet. (To insure adequate ventilation, allow for a minimum of 1/4"
clearance around the top and bottom covers.)
2. RAPID DESK CHARGER: Locate the Rapid Desk Charger on a desk
or other flat surface near a 120/220 Vac 50/60 Hz source and plug into
the outlet. (To insure adequate ventilation, allow for a minimum of
1/4" clearance around the top and bottom covers.)
Refer to Universal Desk Charger Maintenance Manual if it is necessary
to change the charger sleeve or to replace printed wiring boards,
components, or assemblies.
Only an authorized or certified electronic technician should attempt to
disassemble or service the charger.

INSTALLATION

NOTE
9