HUSTLER FasTrak SD Operator's Manual page 36

Verify safety start interlock system
Visually inspect unit for loose hardware and/or damaged parts
Visually inspect tires
Check oil level, engine (1)
Clean air intake screen (4)
Check fuel level
Blades - sharpen & securely fastened
Discharge chute - securely in place & in lowest position
Replace air cleaner paper element (4)
Clean engine and transaxle compartment
Change transaxle oil and filter (7)
Grease deck height pivots
Grease front wheel bearings (mowers built prior to serial number 1308000)
Change engine oil and filter (1) (3)
Clean cylinder and head fins (a)
Check battery connections
Check tire pressure with a gauge
Check hydraulic oil level
Clean engine exterior (a)
Clean & regap spark plugs (a)
Check pump and deck belt tension and condition (5)
Check fuel system (6)
Check hydraulic lines (6)
Check fuel valve and grommet (6)
Tighten lug nuts on wheels (2)
Change fuel filter (6)
Replace spark plugs
Check ROPS mounting hardware (9)
Replace fuel evaporation system filter (8)
NOTES:
1.
Initial oil change is after 5 hours of operation. Thereafter, change oil after every 40 hours operation. Change more often under dusty or dirty conditions and dur-
ing hot weather periods.
2. Torque initially and after first 2 hours of operation.
3. Change engine oil filter per the engine manufacturer's recommendations. Refer to Engine Owner's Manual for recommendations and other maintenance items..
4. Service more often under dusty or dirty conditions.
5.
Pump drive belt only - Inspect every 100 hours and replace if worn or cracking is noticed. Otherwise, replace every 200 hours or 2 years whichever comes
first.
6.
Check fuel system for any crack or leaks including, but not limit to, fuel line hoses, fuel valve, vent line hoses, vent valve, vapor valve, carbon canister, and
grommets. Repair as needed.
7. Initial system oil and filter change must be after the first 75 hours of use or 1 year whichever comes first. Thereafter, replace filter and oil in each transaxle every
2 years or 200 hours, whichever comes first.
8.
More often under dusty or dirty conditions and during hot weather.
9.
Inspect ROPS after the first 20 hours of operation and then after every 500 hours of operation or yearly whichever comes first.
REFERENCES:
A. Refer to engine owner's manual for engine service information.
NOTE: After completing maintenance cycle (500 hours), repeat cycle.
REV G
Maintenance Schedule
Figure 4-15, Figure 4-16, Figure 4-17,
Figure 4-18, Figure 4-19, Figure 4-20, Figure 4-21,
SERVICE AT
INTERVALS INDICATED
WEEKLY
OR 50
HOURS
Prior to each use or every 4 hours
Prior to each use or every 4 hours
Every 200 hours or 2 years
X
X
X
X
X
X
X
X
4-10
MONTHLY ANNUALLY
OR 100 OR 300
HOURS HOURS
Prior to each use
Prior to each use
Prior to each use
Prior to each use
Prior to each use
Prior to each use
As needed
Daily
X
X
X
X
X
X
X
X
X
X
602901