Martin MAC 101 User Manual page 4

• Do not expose the fixture to rain or moisture.
• Refer any service operation not described in this manual to a qualified technician.
• Socket outlets used to supply MAC 101 fixtures with power or external power switches must be located
near the fixtures and easily accessible so that the fixtures can easily be disconnected from power.
P R O T E C T I O N F R O M B U R N S A N D F I R E
• Do not operate the fixture if the ambient temperature (Ta) exceeds 40° C (104° F).
• The exterior of the fixture becomes hot during use. Avoid contact by persons and materials. Allow the
fixture to cool for at least 10 minutes before handling.
• Keep all combustible materials (e.g. fabric, wood, paper) at least 100 mm (3.9 in.) away from the head.
• Keep flammable materials well away from the fixture.
• Ensure that there is free and unobstructed airflow around the fixture.
• Do not illuminate surfaces within 200 mm (7.9 ins.) of the MAC 101.
• Do not attempt to bypass thermostatic switches or fuses.
• If you relay power from one fixture to another using power throughput sockets, do not connect more than
ten MAC 101 fixtures in total to each other in an interconnected chain.
• Connect only other MAC 101 fixtures to MAC 101 power throughput sockets. Do not connect any other
type of device to these sockets.
• Do not stick filters, masks or other materials onto any optical component.
• Do not modify the fixture in any way not described in this manual
• Install only genuine Martin parts.
P R O T E C T I O N F R O M I N J U R Y
• Do not look continuously at LEDs from a distance of less than 8.3 meters (27 ft. 3 inches) from the front
surface of the fixture without protective eyewear such as shade 4-5 welding goggles. At less than this
distance, the LED emission can cause eye injury or irritation. At distances of 8.3 meters (27 ft. 3 inches)
and above, light output is harmless to the naked eye provided that the eye's natural aversion response is
not overcome.
• Do not look at LEDs with magnifiers, telescopes, binoculars or similar optical instruments that may
concentrate the light output.
• Ensure that persons are not looking at the LEDs from within 8.3 meters (27 ft. 3 inches) when the product
lights up suddenly. This can happen when power is applied, when the product receives a DMX signal, or
SERVICE
when
• If suspending from a rigging structure, fasten the fixture to a rigging clamp with an M12 bolt screwed into
the threaded hole in the center of the base of the fixture. The bolt must protrude at least 20 - 30 mm
(0.8 - 1.2 ins.) into the fixture. If the fixture is suspended by any other method, an M12 bolt must be
tightened into this hole so that it protrudes at least 20 - 30 mm (0.8 - 1.2 ins.) into the fixture.
• Install as described in this manual a secondary attachment such as a safety cable that is approved by an
official body such as TÜV as a safety attachment for the weight of all the fixtures it secures. The safety
cable must comply with EN 60598-2-17 Section 17.6.6 and be capable of bearing a static suspended load
ten times the weight of the fixture.
• Ensure that any supporting structure and/or hardware used can hold at least 10 times the weight of all the
devices they support.
• Allow enough clearance around the head to ensure that it cannot collide with an object or another fixture
when it moves.
• Check that all external covers and rigging hardware are securely fastened.
• Block access below the work area and work from a stable platform whenever installing, servicing or
moving the fixture.
• Do not operate the fixture with missing or damaged covers, shields or any optical component.
4
menu items are selected.
MAC 101 user manual