General Repair Information - Graco LTS 15 Repair And Parts Manual

Airless
Table of Contents

Advertisement

General Repair Information

General Repair Information
Flammable materials spilled on hot, bare, motor
could cause fire or explosion. To reduce risk of
burns, fire or explosion, do not operate sprayer with
cover removed.
To reduce risk of serious injury, including electric
shock:
• Do not touch moving or electric pars with fingers or
tools while testing repair.
• Unplug sprayer when power is not required for
testing.
• Install all covers, gaskets, screws and washers
before you operate sprayer.
Keep all screws, nuts, washers, gaskets, and elec-
trical fittings removed during repair procedures.
These parts usually are not provided with replace-
ment kits.
Test repairs after problems are corrected.
If sprayer does not operate properly, review repair
procedure to verify you did it correctly. See Basic
Troubleshooting, page 13 and Advanced Trou-
bleshooting, page 18.
Overspray may build up in the air passages.
Remove any overspray and residue from air pas-
sages and openings in the enclosures whenever
you service sprayer.
Do not operate the sprayer without the cover in
place. Replace if damaged. Covers direct cooling air
around motor to prevent overheating
12
NOTICE
• Do not run sprayer dry for more than 30 seconds.
Doing so could damage pump packings.
• Protect the internal drive parts of this sprayer from
water. Openings in the cover allow for air cooling of
the mechanical parts and electronics inside. If water
gets in these openings, the sprayer could malfunc-
tion or be permanently damaged.
• Prevent pump corrosion and damage from freezing.
Never leave water or water-base paint in sprayer
when its not in use in cold weather. Freezing fluids
can seriously damage sprayer. Store sprayer with
Pump Armor to protect sprayer during storage.
313036N

Advertisement

Table of Contents
loading

This manual is also suitable for:

Lts 17Prolts 17Prolts 19

Table of Contents