GE JVM1850 Owner's Manual page 35

Replacing the light bulbs.
Remove screws
Cooktop Light/Night Light
On models JVM1850 and JVM1851, replace the
burned-out bulb with a 40-watt incandescent bulb
(WB36X10003), available from your GE supplier.
On models JVM1860 and JVM1861, replace the
burned-out bulb with a 10-watt halogen bulb
(WB36X10163), available from your GE supplier.
To replace the bulb(s), first disconnect the
1
power at the main fuse or circuit breaker panel
or pull the plug.
Remove the screw at the outside edge of the
2
light cover and push on the inside edge of the
cover to open.
Be sure the bulb(s) to be replaced are cool
3
before removing. After breaking the adhesive
seal, remove the bulb by gently turning.
Replace the screw. Connect electrical power
4
to the oven.
Oven Light
Replace the burned-out bulb with a 10-watt halogen
bulb (WB36X10163), available from your GE supplier.
To replace the oven light, first disconnect the
1
power at the main fuse or circuit breaker panel
or pull the plug.
Remove the top grille by taking out the screws
2
on top of the grille that hold it in place and
sliding the grille to the left (opening the door
makes grille removal easier).
Next, remove the screw located above the door
3
near the center of the oven that secures the
light housing.
Replace the grille and screws. Connect electrical
4
power to the oven.
www.GEAppliances.com
35