Table of Contents
Advertisement
Table 3-11
Connection Configurations
Parameter
RTSP Port
HTTPs
HTTPs Port
PPPoE
Figure 3-22
PPPoE Configuration Interface
1.
Enter the PPPoE Username and Password that you received from the Internet Service
Provider (ISP), and enable the PPPoE function.
2.
Click to Save the current setup, and then reboot the camera to activate this new setup.
The camera connects to the internet via PPPoE after rebooting.
3.
Find the IP address in the WAN from the IP address column.
Function
The default is 554. The RTSP stream query format is:
Main stream:
rtsp://username:password@ip:port/cam/realmonitor?
channel=1&subtype=0
Sub stream:
rtsp://username:password@ip:port/cam/realmonitor?
channel=1&subtype=1
You are required to manually enter the following four items:
username/password/IP, and port.
IP: The camera's IP.
Port: The default is 554. You can leave this field blank if you are
using the default value.
Follow standard RTP protocols, and when the encoding mode is
MJPEG, the maximum resolution only supports 2040x2040.
Enable the HTTPs port.
The default is 443.
Web Operation | 61
800-18161V1 - A - 07/2014
Advertisement
Table of Contents
