Samsung SNF-7010 User Manual page 22

installation & connection
Ethernet Connection
Connect the Ethernet cable to the local network or to the Internet.
Power Supply
Use the screwdriver to connect each line (+, –) of the power cable to the corresponding
power port of the camera.

J
If both PoE and DC12V are applied simultaneously, the product will be supplied with power from
PoE.
- You can also use a router featuring PoE to supply power to the camera.
- Use PoE that is compliant with the IEEE802.3af protocols.

Be careful not to reverse the polarity when you connect the power cable.

If you want to connect an external device, you must turn off the external device before proceeding.
Connecting a connector cable (SNF-7010VM)
Connect the M12 male connector into the hole of the M12 Female connector of the
camera.

M
This camera uses Female, D-coded types.

PoE (Power over Ethernet) is supported.

You are recommended to use a shielded network connector.

J
Connect this camera to a shielded network cable (STP).

Please, use 4 poles, Male, D-coded type external cables that
meet the M12 specification.

Check whether the PoE device is properly connected to the
ground.
22_ installation & connection
RX-
TX-
TX+
RX+