Cambridge Audio Audio Cable LK10 Installation Manual page 11

For the LK10 to receive commands, it must be first put into Learn mode. The LK10 has a
series of menus that can be accessed by pressing and holding the Shift/Set button on the
front panel. The menu options are continuously scrolled on the LK10 display until you
release the Shift/Set button.
Follow the next steps to complete the cloning operation:
LK10 keypad - Receiving data
1
1. Press and hold the Set button for five
seconds. When 'LEARN' is displayed,
release the button. 'READY' will then be
displayed on screen.
4
4. 'RXING..' will then be displayed, to
indicate it is receiving data.
LR10 remote - Transmitting data
2
2. Press the
until 'TRX' is flashing.
3
3. Press the Enter button on the remote.
Display shows 'SENDING'.
LK10
button on the remote
11