Polaris 600 INDY Voyager 2014 Owner's Manual page 54

THE PERFECT FIT
Handlebar Adjustments
Handlebar Position
1. Loosen the four bolts on the bottom of the adjuster block. If
necessary, pry the blocks apart with a screwdriver.
2. Adjust the handlebar forward or rearward to the desired position.
3. Tighten the bolts.
Handlebar Angle
1. Loosen the four bolts on the top
of the adjuster block. If
necessary, pry the blocks apart
with a screwdriver.
2. Adjust the handlebar forward
or rearward to the desired
angle. Be sure handlebars,
brake lever and throttle lever
operate smoothly and do not hit
the gas tank, windshield or any
other part of the machine when
turned fully to the left or right.
If necessary, loosen the set
screws for the left and right
controls, rotate the controls
slightly, then tighten the set
screws to the proper torque.
NOTICE: Do not stretch wires while adjusting the controls. Stretching the wires
could damage the handwarmers.
• Right control torque: 27 in. lbs. (3.05 Nm) +/- 10%.
• Left control torque: 24 in. lbs. (2.7 Nm) +/- 10%.
3. Tighten the bolts.
52
Loosen top bolts to adjust
handlebar angle
Loosen bolts to
adjust handlebar
angle