Technical Specifications - Cambridge Audio Audio Cable KP10 Installation Manual

TECHNICAL SPECIFICATIONS

Input impedance
Frequency response
THD
S/N ratio
Volume control range
Bass control range
Treble control range
Balance control range
Preamp output
IR pass through
Speaker impedance
Power requirement
This guide is designed to make installing and using this product as easy as possible. Information in this document has been carefully
checked for accuracy at the time of printing; however, Cambridge Audio's policy is one of continuous improvement, therefore design and
specifications are subject to change without prior notice. If you notice any errors please feel free to email us at:
support@cambridgeaudio.com
This document contains proprietary information protected by copyright. All rights are reserved. No part of this manual may be
reproduced by any mechanical, electronic or other means, in any form, without prior written permission of the manufacturer. All
trademarks and registered trademarks are the property of their respective owners.
Incognito and Incognito Ready are trademarks of Cambridge Audio Ltd. All rights reserved.
© Copyright Cambridge Audio Ltd 2005
A-BUS and A-BUS Ready are registered trademarks of LeisureTech Electronics Pty Ltd Australia.
18 Incognito KP10
45 k ohms
20Hz – 20kHz +/- 1dB
<0.2% @ 1W, 20Hz – 20 kHz
> 80 dB 'A' weighted
- 80 dB, 36 steps
+/- 16 dB, 2 dB steps
+/- 16 dB, 2 dB steps
+/- 40 dB, 9 steps either way
Variable level, follows volume setting
34–40 kHz and 54–58 kHz
modulation frequencies supported
4–8 ohms
24 V DC @ 1A max (supplied by hub)