Table of Contents
Advertisement
[Upgrade Mode]
Defines the medium used to receive software updates
and new settings.
[RF]: All settings and new software is received via coaxial
cable.
[IP]: All settings and any new software is received via
Ethernet cable.
[Start Upgrade]
RF upgrade can be manually started by pressing "OK". TV
set will auto switch OFF and will search for new software
and cloning data on RF network.
Note: RF cloning and software upgrade takes between
45-60 minutes depending on network topology.
[Auto Upgrade]
RF upgrade will be enabled automatically at 4 A.M. and 1
P.M. If the TV is in standby will search for SmartInstall
broadcast.
[OFF]: RF cloning and upgrade via SmartInstall is disabled.
[ON]: RF cloning and upgrade via SmartInstall is enabled.
50
Advertisement
Table of Contents
