Sennheiser SD series User Manual page 33

Sharing a workplace
32 | SD Series - User Guide
Using the headset with a third party base station
(DECT-GAP telephone)
Place the headset at a maximum distance of 1 m from the third party
base station.
Simultaneously press and hold the headset's Link button and
Audio button for 5 seconds.
The headset switches to a special pairing mode and the Headset LED
alternately flashes blue/red.
Set the third party base station to a special pairing mode (see the
instruction manual of the third party base station). The default code
for the headset is "0000".
The headset pairs with the third party base station. If pairing is suc-
cessful, the Headset LED goes off.
SD Office – HS
5 s
If pairing is not successful within 60 seconds, the headset switches back to
standby mode.
Pairing the headset again with a SD series base station
Simultaneously press and hold the headset's Link button and
Audio button for 5 seconds.
The headset switches to a special pairing mode and the Headset LED
alternately flashes blue/red.
Place the headset into the magnetic holder of the base station. The
Headset LED flashes 3 times blue and then lights up blue. The base
station and the headset are paired.
SD Pro1 – HS
SD Pro2 – HS
5 s