Table of Contents
Advertisement
7.
Clean the oil strainer screen.
8.
Check that the oil strainer screen, sealing
rubber, and drain bolt O-ring are in good
condition.
9.
Install the O-ring to the oil drain bolt.
10.
Install the oil strainer screen, spring, and
drain bolt.
11.
Tighten the oil drain bolt to the specified
torque:
11 lbf·ft (15 N·m , 1.5 kgf·m)
12.
Pour the recommended oil into the crankcase,
approximately:
1.1 US qt (1.0 )
13.
Install the oil filler cap/dipstick securely.
14.
Start the engine and let it idle for 3-5
minutes. Stop the engine. Wait 2-3 minutes.
15.
With the motorcycle held upright on level
ground, check the oil level.
If needed, add oil (page
the upper level mark. (Do not overfill.)
16.
Check for oil leaks.
Engine Oil
63
) until it reaches
Servicing Your Honda
65
Hide quick links:
Advertisement
Table of Contents
