Advertisement
EXT. LEFT
32
INTERNAL OFF
33
34
+
Since speakers can have quite an impact on the sound of a guitar amp, both the headphones
and LINE OUT/TAPE OUT signals are frequency-corrected (Speaker Emulation). Without this
frequency correction, extreme treble frequencies would deteriorate the sound. You can still
tap the unprocessed signal directly after the pre-amp (INSERT SEND jack), without interrupting
the signal path in the amplifier (INSERT RETURN jack may not be used in this case). Starting
with a certain volume level, low-impedance headphones may begin to produce distortion. In
such a case, please reduce the volume by turning down the VOLUME controls.
SLAVE IN
35
+
Since the SLAVE IN jacks are configured as insert jacks, you can also insert an external stereo
effects device. Use a dedicated insert cable which has a 1/4" stereo plug on the one end, and
two mono plugs on the other. Connect the tip contact (return) with the output, and the ring
contact (send) with the input of the effects device (see chapter 2.3).
TAPE OUT
36
TAPE IN
37
LINE OUT
38
AUX IN
39
40
INSERT SEND
INSERT RETURN
41
+
Please note that when using the serial effects path, the external effect should not be set to
100 % wet (100 % effect signal); otherwise, there will be no direct signal portion fed back to the
ULTRATWIN.
42
EXT. RIGHT
W
FOOTSWITCH
W
Advertisement
