Starting Warm Engine; Stopping Engine - Echo PB-603 Operator's Manual

STARTING WARM ENGINE

The starting procedure is the same as Cold Start except DO NOT close
the choke.
1. Throttle Lever/Stop Switch
Move throttle lever (A) forward to idle position. Slide stop switch
(B) forward to run position.
2. Primer
Pump primer bulb (D) until fuel is visible and flows freely in the
clear fuel tank return line. Pump bulb an additional 4 or 5 times.
3. Recoil Starter
Pull recoil starter handle (E) and engine should start.
NOTE
If engine does not start after 5 pulls, use cold start procedures.

STOPPING ENGINE

1. Throttle Lever
Move throttle lever (A) forward to idle position and allow engine to
return to idle before shutting off engine.
2. Stop Switch
Slide stop switch (B) to Stop position.
WARNING
If engine does not stop when stop switch is moved to STOP
position, close choke - COLD START position - to stall engine.
Have your ECHO dealer repair stop switch before using blower
again.
DANGER
P B
OWER LOWER
O ' M
PERATOR S
B
A
D
E
B
A
13
ANUAL