Assembly; Install Blower Pipes - Echo PB-603 Operator's Manual

10
A
SSEMBLY
WARNING
Never perform maintenance or assembly procedures with engine
running, or serious personal injury may result.

INSTALL BLOWER PIPES

1. Assemble clamps (A) onto both ends of flexible pipe (B).
2. Assemble straight pipe with swivel (C) into flexible pipe (B).
NOTE
Assure throttle cable is not kinked or twisted before assembly.
3. Position throttle cable so it passes between the elbow (G) and frame
and runs along the top of the flexible pipe. Remove clamp screw (D)
on handle (E). Spread clamp and install onto straight pipe with
swivel (C).
4. Assemble flexible pipe (B) to elbow (G) on blower.
NOTE
A light lubricant may be used to ease assembly of flexible pipe to
blower elbow.
5. Tighten clamps (A).
6. Install throttle cable ties (F) in grooves at each end of flexible pipe.
7. Move handle (E) to desired position. Tighten knob (H) hand tight
and tighten clamp screw (D).
NOTE
Check throttle for freedom of movement and that wide open throttle/
low idle extremes are adjusted properly, if not, consult your Echo
Dealer.
8. Assemble straight pipe (J) to pipe with swivel (C), turning straight
pipe counter-clockwise to lock in place. Assemble straight pipe (K)
to straight pipe (J) the same way.
9. Make sure all clamps are tight.
DANGER
E
A
B
C
G
A
A
B
G
F
K
H
J
C
D
D
E