CDA HG6150 Installation, Use And Maintenance Manual page 20

2. Position the hob seal, as shown in the diagram below (Fig. 13),
ensuring that the ends meet without overlapping. Do not use silicone
type sealant.
3. Secure the hob to the worktop using the fixing brackets and screws
supplied, as shown in the following diagram (Fig. 14). Remove any
excess sealant after tightening the brackets.
150mm
Fig. 11
Fig. 13
20
>61.5mm
477mm
557mm
150mm
Fig. 14
Fig. 12
3cm
4cm