Troubleshooting - AcuRite 02038 Instruction Manual

LOW records.
To manually clear all of today's HIGH recorded values, press and hold the
" " button for 2 seconds. Dashes display to confirm you have cleared the
HIGH records.
Press the " " button to cycle through the all-time high and low recorded
values (one record is shown at a time) for outdoor and indoor temperature and
humidity. Located in the top right corner of the screen, a date and time stamp
are shown for when each value was recorded. You will automatically exit
all-time records if no buttons are pressed for 5 seconds.
To manually clear an all-time LOW record, press and hold the "
for 2 seconds while viewing the record you wish to clear. Dashes display to
confirm you have cleared the record.
To manually clear an all-time HIGH record, press and hold the "
for 2 seconds while viewing the record you wish to clear. Dashes display to
confirm you have cleared the record.

Troubleshooting

No outdoor sensor
reception
no bars
Display screen
not working
Outdoor
temperature
is flashing or
showing dashes
If the wireless signal indicator shows no bars:
• Relocate the display unit and/or the outdoor sensor.
The units must be within 330 ft (100 m) of each other.
 Make sure both units are placed at least 3 feet (.9m)
away from electronics that may interfere with the
wireless communication (such as TVs, microwaves,
computers, etc).
• Use standard alkaline batteries (or lithium batteries in
sensor when temperature is below -4ºF/-20ºC). Do not
use heavy duty or rechargeable batteries. NOTE: It
may take up to 20 minutes for display unit and sensor
to synchronize after batteries are replaced.
• Check that the batteries are installed correctly.
Batteries may need to be replaced.
• Reset display by pressing the RESET button, located
on the back of the display unit. Date and time will
need to be entered after a reset.
Flashing of the outdoor temperature is generally an
indication of wireless interference.
1. Bring both the sensor and display unit indoors and
remove at least one battery from each.
2. Make sure the A-B-C switch on both units match.
3. Reinstall the battery in the outdoor sensor.
4. Reinstall the battery in the display unit.
5. Let the units sit within a couple feet of each other
for about 20 minutes to gain a strong connection.
10
" button
" button