VTech CS6648-2 User Manual page 49

The telephone Caller ID is a subscription
does not service. You must
receive caller subscribe to this service
ID or the from your telephone
telephone service provider for this
does not show feature to work on your
caller ID during telephone.
call waiting.
Both your and the
caller's telephone service
providers must use
equipment compatible with
the caller ID service.
The caller may not be
calling from an area which
supports caller ID.
The caller ID information
displays after the first or
second ring.
The display The handset may be out of
shows Out of range. Move it closer to the
range or no telephone base.
pwr at base.
Make sure the power cord
is securely plugged into
the telephone base. Use a
working electrical outlet not
controlled by a wall switch.
I cannot The handset does not
hear any have a speakerphone.
instruction from When recording, playing
the handset or deleting your own
when I try to announcement, the
record, play or instructions are announced
delete my own through the handset
announcement. receiver. Make sure you
place the handset receiver
close to your ear.
The outgoing When recording the
announcement announcement, make sure
is not clear. you speak in a normal
tone of voice towards the
microphone of the handset.
Make sure there is no
background noise when
recording.
The answering
system does
not record
messages.
The answering
system does
not announce
the correct day
of the week
for recorded
messages time
stamp.
The messages
on the
answering
system are
very difficult to
hear.
The messages
on the
answering
system are
incomplete.
42
Make sure the answering
system is on. When the
answering system is on,
ANS ON should display
on the handset and the
telephone base.
When the answering
machine memory is full,
it does not record new
messages until some old
messages are deleted.
If you subscribe to
voicemail service, change
the number of rings so
that your answering
system answers before
your voicemail service
answers. To determine how
many rings activate your
voicemail service, contact
your telephone service
provider.
Make sure you have set
the date and time. See
Configure your telephone
section.
Press VOL+ on the
handset or p/VOLUME
on the telephone base
to increase the listening
volume.
If a caller leaves a very
long message, part of
it may be lost when
the answering system
disconnects the call after
the preset recording time.
If the memory on the
answering system
becomes full during a
message, the answering
system stops recording
and disconnects the call.
If the caller's voice is very
soft, the answering system
may stop recording and
disconnect the call.