Peavey Rage 158 Operating Manual page 21

REAR PANEL
1
1. AC POWER CORD
This line cord provides the AC power to the unit. Connect the line cord to a properly
grounded AC supply. Damage to the equipment may occur if improper line voltage is used.
(See voltage marking on unit.) Never remove or cut the ground pin of the line cord plug.
NOTE: FOR UK ONLY
As the colors of the wires in the mains lead of this apparatus may not correspond with the colored
markings identifying the terminals in your plug, proceed as follows: (1) The wire which is colored
green and yellow must be connected to the terminal which is marked by the letter E, or by the earth
symbol, or colored green or green and yellow. (2) The wire which is colored blue must be connected
to the terminal which is marked with the letter N, or the color black. (3) The wire which is colored
brown must be connected to the terminal which is marked with the letter L or color red.
FRONT PANEL
4 5
2. POWER SWITCH
Press the switch to the "ON" position to apply power to the unit. The POWER LED (3) will
illuminate to indicate power has been supplied to the unit.
3. POWER LED
Illuminates when power has been supplied to the unit.
4. INPUT
Input jack will accept signals from all types of guitar pickups. Be sure to use a high quality
shielded instrument cable to connect the guitar to the amplifier.
5. VOLUME
Controls the volume level of the Clean channel and is not affected by the Lead, Pre or Post
Gain controls.
6. CHANNEL SELECT SWITCH
Allows selection of the Lead or Clean channel. The "down" position of the switch selects the
Lead channel and the "up" position selects the Clean channel.
ENGLISH
6 7 8 9
Rage 158
®
10 11 12 3 2