How To Assemble; How To Operate - Vax C91-M4 Series Instruction Manual

Table of Contents

Advertisement

C91-M4 Series User Guide.qxd:Vax VZL-7015(AT) User Guide
www.vax.co.uk

3. How to Assemble

IMPORTANT: Always unplug the vacuum cleaner
!
from the electrical outlet before assembling or
removing the accessories.
1.
Insert the flexible hose (Fig.3/1) into the inlet on the
main body of the vacuum cleaner. Making sure the
projected parts on the hose are aligned. Turn the
hose to the right until it clicks into lock position.
Fig.3/1
2.
Push the telescopic extension tube on to the end of
the handle (Fig.3/2).
Fig.3/2
3.
The telescopic tube can be lengthened or shortened
by pushing the button in and sliding the tube apart
or together as required (Fig.3/3).
Fig.3/3
4.
Fit either the combination floor head or TurboTool
by pushing onto the extension tube (Fig.3/4).
Fig.3/4
4
assembly / operation
23/3/09

4. How to Operate

Cord Release
Fully unwind the power cord. A yellow mark on the power
cord indicates the recommended cord length. Do not
exceed the cord length beyond the red mark.
On/off Button
1.
Insert the plug into the electrical outlet.
2.
Press the on/off switch located on the top of the
vacuum cleaner, to switch on the vacuum cleaner
and press the button again to turn the vacuum
cleaner off.
Carpet Cleaning
Attach the TurboBrush to the end of the extension tube.
For vacuuming large carpeted areas.
Hard Floor Cleaning
Attach the hard floor tool to the end of the extension
tube. For vacuuming parquet and laminate coverings.
Cord Rewind
To rewind the power cord, press the cord rewind button,
located on the top of the vacuum cleaner, and guide the
power cord with one hand. This will prevent the cord from
whipping which could cause damage or injury.
Carry Handle
Use the carry handle located at the rear end of the
vacuum cleaner to move from room to room.
Hose Storage
For convenience there is a parking slot located at the rear
of the vacuum cleaner where the floor tool and hose can
be parked for carrying and storage.
TurboTool
Attaches to the end of the telescopic tube or end of the
hose handle. TurboTool is used for vacuuming pet hair,
stair and upholstery cleaning.
NOTE: Do NOT use the TurboTool on suede or leather
surfaces.
Stretch hose (C91-M4-S only)
For full height stair cleaning.
IMPORTANT: This should not be used as the main
!
vacuum hose.
NOTE: For stair cleaning the unit should always be placed
at the bottom of the stairs.
NOTE: The stretch hose is recommended to be used for a
period of 20 minutes max.
10:19
Page 4

Advertisement

Table of Contents
loading

Table of Contents