Invacare Comet Operating Manual page 36

Blink
code
4 Power time
exceeded
5 Brake failure
No neutral position
6
when switching
Scooter on.
36
Fault Consequence
for the Scooter
Stops driving
Stops driving
Stops driving
Comments
•
The maximum current was exceeded
over too long a period, probably because
the motor was overloaded or has been
working against an immovable
resistance. Switch the scooter off, wait a
few minutes and then switch on again.
•
The electronic system has determined a
motor short-circuit. Check the wiring
harness for short-circuit and check the
motor.
•
Contact your Invacare® dealer.
•
Ensure that the disconnection lever is
pressed in.
•
There is a defect in the braking coil or in
the cabling. Check the magnetic brake
and cabling for open or short-circuited
circuitry. Contact your Invacare® dealer.
•
Drive lever is not in neutral when the
keyswitch was turned. Put the drive lever
in neutral, turn the power off and then
turn on again.
•
It may be necessary to recalibrate the
drive lever. Contact your Invacare®
dealer.