Korg Kronos Quick Start Manual page 26

Saving and loading data
9. Use ".KSC Allocation" to specify how the sample
data will be loaded, and whether or not existing
sample data will be erased.
Append will leave all currently‐loaded Sampling
Mode, User Sample Bank, and/or EXs data intact.
Sampling Mode Multisamples and Samples will be
loaded into the next available vacant numbers
following the existing data.
Clear Sampling Mode Data will erase all
Multisamples and Samples from Sampling Mode, and
load the data in the same configuration with which it
was saved. Existing EXs and User Sample Bank data is
left intact.
Clear All is similar to Clear Sampling Mode Data,
above, but also un‐loads existing EXs and User Sample
Bank data before loading the new .KSC file. This frees
up the most memory for the new .KSC.
You can use the information at the bottom of the dialog
box, including Memory Required, (Memory)
Available, and Enough slots for Samples & MS, to
determine whether or not you need to free up room for
the new .KSC.
10.Set the Load Method as desired.
This sets the preferred way to load the EXs and User
Sample Bank data in the KSC: load them into RAM,
use Virtual Memory, or use the setting stored in the
KSC. If the KSC has no EXs or User Sample Bank data,
this will be grayed out.
11.Press the OK button to load the data.
Never disconnect USB devices or remove data‐
storage media while loading or saving.
When loading Programs, Combinations, Songs, Set
Lists, Drum Kits, Wave Sequences, or KARMA User
GEs, make sure that the Global Basic Setup page's
Memory Protect settings are turned off (unchecked).
If they are on, you won't be able to load the data.
Loading individual banks from a .PCG file
1. Go to the Load page.
2. Select the .PCG file containing the data you want
to load.
3. Press the Load button.
4. Set the .PCG Contents to load the desired
individual banks.
5. Select the bank to load into via the "To" parameter.
26
En-
Automatic reference correction
If you set .PCG Contents and To to different banks,
any references in the data will be updated to match the
new bank. For instance, let's say that you're loading
from the PCG's Bank I‐A into Bank U‐G. If the PCG's
Combinations used Programs from Bank I‐A, they will
be updated to the use the Programs' new locations in
Bank U‐G. The same is true for any Drum Kits or Wave
Sequences used by Programs.
If you're loading sequencer data at the same time (with
Load .SNG too checked), any Program and Bank
Change messages within the Songs will also be
corrected.
Loading multiple files at once
You can select two or more files at once, and load them
in a single operation. To do so:
1. Press the Multiple Select check‐box at the bottom
of the screen, so that it's enabled.
This can be handy for loading multiple sample files at
once, importing banks of DX sounds, and so on.
Multiple Select works for other disk operations as
well, including Delete (so be careful!).
Note that when Multiple Select is on, you can't change
to a different directory. When you're done, turn it off
again.
You can also use "wild cards" to select multiple files.
For more information, see "Loading multiple files at
once" under the "Load selected" menu command in
the PG's Disk chapter.