Adapting The Cooker To Different Types Of Gas - Indesit IT50D S Operating Instructions Manual

Disposing of the appliance
When disposing of the appliance please remove the
plug by cutting the mains cable as close as
possible to the plug body and dispose of it as
described above.
Adapting the cooker to different types of
gas
In order to adapt the cooker to a different type of
gas with respect to the gas for which it was
produced (indicated on the label attached to the lid),
follow these steps:
a ) a ) replace the hose holder mounted on the appliance a ) a ) a )
with that supplied in the bag of "cooker
accessories".
b ) b ) b )Replacing the burner nozzles on the hob: b ) b )
• remove the grids and slide the burners from their
housings;
• unscrew the nozzles using
a 7 mm socket spanner, and
replace them with nozzles for
the new type of gas (see table
1 "Burner and nozzle
characteristics").
• replace all the components
by repeating the steps in
reverse order.
c ) c ) c ) c ) Minimum regulation of the hob burners:
c )
• turn the tap to minimum;
• remove the knob and
adjust the regulation screw,
which is positioned in or next
to the tap pin, until the flame
is small but steady.
! in the case of liquid gas, the
regulation screw must be
screwed in to the bottom.
• check that the flame does not turn off when you
turn the tap quickly from high to low.
d ) d ) d ) d ) d )Regulating the primary air of the burners:
The primary air of the burners requires no regulation.
Important Important Important Important Important
On completion of the operation, replace the old
rating sticker with one indicating the new type of gas
used. This sticker is available from our Service
Centres.
Note Note Note Note Note
Should the pressure of the gas used be different (or
vary) from the recommended pressure, it is
necessary to fit a suitable pressure regulator onto
the inlet pipe in compliance with current National
Regulations relative to "regulators for channelled
gas".
! VERY HOT SURFACES ! VERY HOT SURFACES ! VERY HOT SURFACES
FOOD OR GREASE ON THESE
SURFACES COULD CAUSE
SMOKE AND POSSIBLY EVEN BURN
YOU MUST KEEP THE OVEN
AND GRILL CAVITIES CLEAN
! ATTENTION ! ATTENTION ! ATTENTION
DURING INSTALLATION
THE FEET OF THE APPLIANCE
MUST BE LOWERED SO THAT
AN AIR GAP OF AT LEAST
10MM (1CM) IS LEFT BETWEEN
THE BASE OF THE APPLIANCE
AND THE FLOOR.
! ATTENTION ! ATTENTION ! ATTENTION
WHEN USING THE MAIN OVEN
YOU MUST ENSURE THAT THE
BASE OF THE CAVITY IS NOT
COVERED WITH ALUMINUM
FOIL, UTENSIL OR ANY OTHER
FORM OF COVERING. FAILURE
TO DO THIS MAY RESULT IN
THE CAVITY BEING DAMAGED.
5
GB