Selecting The Input Signal - Panasonic TH-42PH20U Operating Instructions Manual

Selecting the input signal

Select the input signals to be connected by installing the optional Terminal Boards.
Press to select the input signal to be played back from the equipment which
has been connected to the Plasma Display.
Input signals will change as follows:
VIDEO: Video input terminal in AV IN (VIDEO).
COMPONENT*: Component or RGB input terminal in COMPONENT/RGB IN.
HDMI: HDMI input terminal in AV IN (HDMI).
DVI: DVI input terminal in DVI-D IN.
PC: PC input terminal in PC IN.
* "COMPONENT" may be displayed as "RGB" depending on the setting
of "COMPONENT/RGB-IN SELECT". (see page 39)
When an optional Terminal Board is installed:
PC
SLOT INPUT: Input terminal in Terminal Board
Note:
When a Terminal Board incompatible with the Plasma Display is
installed, "NON-COMPATIBLE FUNCTION BOARD" is displayed.
When a Terminal Board with dual input terminals is installed:
SLOT INPUT A, SLOT INPUT B: Dual input terminal in Terminal Board.
Notes:
• Selecting is also possible by pressing the INPUT button on the unit.
• Outputs the sound as set in "Audio input select" in the Options menu. (see page 49)
• Select to match the signals from the source connected to the component/RGB input
terminals. (see page 39)
• Image retention (image lag) may occur on the plasma display panel when a still picture
is kept on the panel for an extended period. The function that darkens the screen slightly
is activated to prevent image retention (see page 50), but this function is not the perfect
solution to image retention.
16
PC VIDEO COMPONENT*
SLOT INPUT VIDEO
PC SLOT INPUT A
HDMI DVI
COMPONENT
SLOT INPUT B VIDEO
HDMI DVI
INPUT MENU -/ VOL
INPUT
COMPONENT HDMI
+ / ENTER/
+
MENU - / VOL / ENTER/
DVI