Daikin FTXS50BVMB Operation Manual page 15

I To 3-D Airflow
1. 3. press "SWING button": the "
the flaps and louvers will move in turn.
I To cancel 3-D Airflow
2. 4. press "SWING button"
Notes on louvers angles
I I I I ATTENTION
• Always use a remote controller to adjust the louvers angles. In side the air outlet, a fan is rotating at a
high speed.
Notes on flap angle
• When "SWING button" is selected, the flaps swinging
range depends on the operation mode. (See the figure.)
Three-Dimensional (3-D) Airflow
• Using three-dimensional airflow circulates cold air,
which tends to collected at the bottom of the room, and
hot air, which tends to collect near the ceiling,
throughout the room, preventing areas of cold and hot
developing.
I I I I ATTENTION
• Always use a remote controller to adjust the flaps angle.
If you attempt to move it forcibly with hand when it is
swinging, the mechanism may be broken.
• Be careful when adjusting the louvers. Inside the air
outlet, fan is rotating at a high speed.
" " " display will light up and
In COOL or DRY mode
STOP
COOL
approx. 10˚~40˚
DRY
approx. 5˚~35˚
In HEAT or FAN mode
STOP
HEAT
approx. 15˚~55˚
FAN
approx. 5˚~55˚
13