Figure 7-3: Site Survey; Figure 7-4: Security Settings - Linksys WET54G-EU v3 User Manual

Wireless-G Ethernet Bridge
and Wireless-B (802.11b) devices in your network. Select 802.11g if you have only Wireless-G devices in your
network. Select 802.11b if you have only Wireless-B devices in your network.
• Wireless Site Survey
The Wireless Site Survey screen, shown in Figure 7-3 shows all the wireless networks detected by the Bridge
and their general information. You can use this screen to connect to one of these networks.
For each wireless network detected, the following information is displayed:
• SSID - The network name. To join a wireless network, click its SSID.
• MAC Address - The MAC address of the network's access point.
• Channel - The channel setting.
• Signal Strength (%) - The percentage of wireless signal strength.
• Mode - The type of wireless standard, network mode, and status of WEP encryption.
Click the Refresh button to obtain the most up-to-date data. Click the Cancel button to close this screen. Click the
Help button for additional on-screen information.
• Security
Security - To enable security, select Enable, then click Edit Security Settings. If you have not enabled
security before clicking on Edit Security Settings, the screen in Figure 7-4 will appear. To disable security,
select Disable.
To save your changes, click the Apply button. Click the Cancel button to cancel your changes. Click the Help
button for additional on-screen information.
Chapter 7: Using the Wireless-G Ethernet Bridge Web-based Utility
Setup

Figure 7-3: Site Survey

Figure 7-4: Security Settings

NOTE: Make sure that your security choice
matches the security choice of the wireless
network you want to join. Otherwise, the
connection will fail.
18