Nikon s4300 Reference Manual page 206

Problem
Monitor is blank.
Monitor is hard to read.
Date and time of
recording are not
correct.
No indicators displayed
in monitor.
Print date not
available.
Date not appearing on
images even when
Print date is enabled.
Time zone and date
setting screen appears
when the camera is
turned on.
Camera settings reset.
Monitor turns off, and
the power-on lamp
flashes quickly.
Cause/Solution
• Camera is off.
• Standby mode for saving power: press the
power switch, the shutter-release button,
A button, c button, or b (e movie-record)
button.
• When flash lamp flashes, wait until flash has
charged.
• Camera and computer are connected via USB
cable.
• Camera and TV are connected via audio/video
cable.
• Adjust monitor brightness.
• Monitor is dirty. Clean monitor.
• If camera clock has not been set, "Date not set"
indicator flashes during shooting and movie
recording. Images and movies recorded before
clock is set are dated "00/00/0000 00:00" or "01/
01/2012 00:00" respectively. Set the correct time
and date from the Time zone and date option
in the setup menu.
• The camera clock is not as accurate as ordinary
watches or clocks. Periodically compare the time
of the camera clock with that of a more accurate
timepiece and reset as required.
Auto info is selected for Photo info in Monitor
settings in the setup menu.
Camera clock has not been set.
• The current shooting mode is one that does not
support Print date.
• Date cannot be imprinted on movies.
Clock battery is exhausted; all settings were
restored to their default values.
Battery temperature is high. Turn off camera and
allow battery to cool down before resuming use.
After the lamp flashes for three minutes, the
camera will turn off automatically. Pressing the
power switch also turns off the camera.
Troubleshooting
A
23
23, E75
55
76, 79
76, E27
88, E68
F5
24, E65
25, E65
88, E68
24, E65
88, E70
24, 25
23
F7