AEG 3531 WK-M GB 949600835 Instruction Book

Wok burner.
Hide thumbs

Advertisement

INSTRUCTION BOOK
GB
Wok burner
3531 WK-m
GB
949600835
1

Advertisement

   Related Manuals for AEG 3531 WK-M GB 949600835

   Summary of Contents for AEG 3531 WK-M GB 949600835

  • Page 1

    INSTRUCTION BOOK Wok burner 3531 WK-m 949600835...

  • Page 2: Your New Appliance

    Your New Appliance Thank you for purchasing an AEG appliance. To enable you to use your new appliance efficiently and safely, please read this instruction book carefully before installing or using the appliance, and retain for future reference. Should the appliance be transferred to a new...

  • Page 3: Table Of Contents

    Table of contents Contents For the user Your new appliance ... 2 Safety information ... 4 Description of the product ... 5 Placement of grid ... 5 Operating instructions ... 6 Burner cover/inner- and outer burner ring... 7 Ignition electrode (A) ... 7 Thermo couple (B) ...

  • Page 4: Safety Information

    Ensure that the control knob is in the OFF position when not in use. Do not use the wok if it is damaged in any way, contact your local AEG Service Centre. Never use plastic or aluminium dishes on the wok.

  • Page 5: Description Of The Product, Placement Of Grid

    Description of the product Burner Knob Placement of grid Guide pins for grid...

  • Page 6: Operating Instructions

    Operating instructions Burner markings The operating knob has a ring showing the scale of markings. Off. Max. flame and ignition position Min. flame...

  • Page 7: Ignition Electrode (a), Ignition

    Burner cover/burner ring Together with the burner ring the burner cover forms a space where the final mixture of gas and air takes place in order to make the gas burn correctly. Please note: It is consequently very important that the burner cover/ring is placed correctly on the burner.

  • Page 8

    The wok-unit has a special pan support which enables use of a wok pot with curved bottom. When using cooking utensils with a flat bottom the diameter of the utensils must not be less than 26 cm.

  • Page 9

    1. Depress and turn the control knob for the burner, the left to Max. flame 2. The ignition electrode will emit sparks, and when the mixture of gas and air is correct, the burner will be ignited. Is not possible to connect the unit to mains, a match may be used to ignite the burner 3.

  • Page 10: Cleaning And Maintenance, Splashguard

    Cleaning and maintenance For reasons of hygiene and safety, the cooking burner must be kept clean. Grease stains and spilled food generate smoke when heated, and can even cause fire. Splashguard The splashguard can be removed to make it easier to clean the surface. What to do: 1.

  • Page 11: Stainless Steel Surfaces

    Stainless steel surfaces Perform daily cleaning with a slightly damp cloth. For more severe soiling, use a liquid cream. Always clean the steel in the direction of the steel finish. To ensure that the steel retains its shine, it is recommended that you use a polishing agent for stainless steel on a regular basis.

  • Page 12: Technical Data

    Technical data Type of gas Adjusted for Natural, G-20 - 20mbar Category and pressures GB: II 20 - 28/37 mbar 2H3+ Max. nominal load Q, H Wok burner = Total= The unit features fully-secured gas taps (thermo-fuse). = Gross calorific value Q = Nominal load Voltage= Ignition transformer=...

  • Page 13: Important Safety Requirments

    Important safety requirments This hob must be installed in accordance with the Gas Safety (Installation and Use) Regulations (Current Edition) and the IEE Wiring Regulations (Current Edition). Detailed recommendations are contained in the following British Standards Codes Of Practice: B.S. 6172/ B.S.

  • Page 14: Gas Connection

    Gas connection Gas installation In accordance with local requirements for domestic gas cooking appliances. Gas installation must only be carried out by an authorised person. For gas types see technical data. Gas connection The gas intake is situated at the lower rear of the appliance.

  • Page 15: Mounting

    Caution: In order to avoid a hazard this appliance must be installed according to these instructions for installation The hob unit can be mounted in any type of kitchen with a table surface whose thickness is between 28 mm and 40 mm. Headroom The distance to any shelves or tops of a cabinet under the hob is to be at least...

  • Page 16

    It is not necessary to attach the reinforcement beam to the work top surface, as it is held in place by a specially designed moulding, which is incorporated in the hob units flanges. The units externally measured length 145 mm: Cooker hood 290 mm: Two-zone ceramic-top electric hob...

  • Page 17: Something Not Working

    Something not working If the hob is not working correctly, please carry out the following checks before contacting your local AEG Service Force Centre. IMPORTANT: If you call out an engineer to a fault caused by incorrect use or installation, a charge will be made even if the hob is under guarantee.

  • Page 18

    Customer Care For general enquires concerning your AEG appliance or for further information on AEG products, please contact our Customer Care Department at the address below or visit our website at www.aeg.co.uk *calls to this number may be recorded for training purposes...

  • Page 19: Guarantee Conditions

    Guarantee conditions AEG offer the following guarantee to the first purchaser of this appliance: 1. The guarantee is valid for 12 months commencing when the appliance is handed over to the first retail purchaser, which must be verified by purchase invoice or similar documentation.

  • Page 20

    Before you move please contact your nearest Customer Care centre, listed below, to give them details of your new home. They will then ensure that the local service organisation is aware of your move and able to look after you and your appliances.

This manual also for:

3531 949600835

Comments to this Manuals

Symbols: 0
Latest comments: