CAMBRIDGE COLONIAL Owner's Manual page 10

OPERATING INSTRUCTIONS
4.2 CONTROL PANEL OPERATING PROCEDURES (CONTINUED)
Flame Operation:
1. To switch on the flame, flip the POWER rocker switch on. The red LED light
turns on.
2. To switch on the flame effect of your fireplace, flip the POWER rocker switch
to on. The flame goes on when the red LED light on the switch turns on.
3. To adjust the brightness of the flame, turn the right-hand dial marked FLAME,
clockwise until it reaches the brightness you desire
Heater Operation:
1. To switch on the heater, flip the POWER rocker switch on.
The red LED light turns on
2. Flip the second rocker switch from the left, marked Heater I.
This switch gives you approximately 675 W of power to your heater.
This switch is for low-level heating. For high-level heating, make sure
the POWER, HEATER I and HEATER II switches are all turned on.
3. To adjust the temperature, turn the left-hand dial marked
TEMPERATURE CONTROL clockwise, until it reaches the temperature you desire.
9
SECTION 4
FLAME
Fig. 6
TEMPERATURE
CONTROL
Fig. 7