Table of Contents
Advertisement
06
INSTALLATION
ADJUSTING THE BOTTOM COVER
When open the shrink package,you will fi nd a calcium plastic board
which is laid on the top of washing machine as shown in fi g.1.The
board is used for reducing noise by pasting it under the cabinet
when setting as shown in fi g.2.
(For HMS1460B/S
HMS1260B/S)
DISMANTLE THE TRANSPORTATION BOLTS
The transportation bolts are designed for clamping anti-vibration components
inside of the washing machine during the transportation process.
1.
Remove the back cover.
2.
Remove the three bolts on the rear side and take out the synthetic
stabilisers from within the machine.
3.
Replace the back cover.
4.
Fill the holes left by the bolts with blanking plugs.
Note:
1.When you replace the back cover,the convexity must face to
outside, and you have to insert the back cover from the two
gaps as shown in fi g.3.
2.Keep the transportation bolts and synthetic stabilisers
in a safe place for later use.
ADJUSTING THE WASHING MACHINE
There are adjustable feet under the bottom of the washing machine. Before use, they should be
adjusted so that the machine is level. This will minimise vibrations and thus noise during use. It will also
reduce wear and tear. We recommend using a spirit level to level the appliance.The fl oor should be as
stable and fl at as possible.
BEFORE USE
2.
1.
3.
4.
fig.3
Advertisement
Table of Contents
