Table of Contents
Advertisement
GB
10.1 Preparation
▶ Take the appliance out of the packaging.
▶ Remove all packaging material including polystyrene base, keep them out of childrens
reach. While opening the package, water drops may be seen on plastic bag and port-
hole. This normal phenomenon results from water tests in the factory.
Note: Packaging disposal
Keep all packaging materials out of children´s reach and dispose them in an environmen-
tally friendly manner.
10.2. OPTIONAL: Adjusting the bottom cover
board
When opening the shrink package, you will find a calci-
um-plastic board (A) (Fig. 10-1). The board is used for
reducing noise after covering the bottom of the cabi-
net.
Only Model HW80-/HW100:
There is also a felt (B) in the package.
1. Past the felt on one side of the calcium-plastic
board (Fig. 10-1).
2. Lay the washing machine down to its side, port-
hole pointing upwards, bottom side towards op-
erator and screw off the four bolts (Fig. 10-2).
3. Place the calcium-plastic board.
Only Model HW80-/HW100:
The felt is pointing inside the appliance.
Screw the bolts through the four holes on the
board on to the tub firmly. Finally set the machine
upright again.
10.3 Dismantle the transportation bolts
The transportation bolts are designed for clamping
anti-vibration components inside the appliance during
transportation to prevent inner damage.
1. Remove the back cover (Fig. 10-3).
2. Remove all 4 bolts on the rear side and take out
plastic spacers (A) from inner side of the machine
(Fig. 10-4).
10-Installation
10-1
1.
B
A
10-3
10-2
2.
3.
10-4
A
25
Hide quick links:
Advertisement
Table of Contents
